ASSESSMENT OF SUSTAINABILITY INDICATORS OF TWO GAS- TURBINE PLANTS WITH NAPHTHA AND NAPHTHA-RFG MIXTURE AS FUELS
DOI:
https://doi.org/10.20319/mijst.2020.61.0114Keywords:
Exergy, Naphtha, Residual Fuel Gas, Sustainability AnalysisAbstract
To enhance sustainability of any energy system exergy based sustainability indicators (exergy efficiency, waste exergy ratio, environmental effect factor and exergetic sustainability index) are used. In the present paper sustainability aspects of two GT based power plant are carried out using sustainability indicators. For this purpose, two GT1) configurations, case A (Naphtha based GT power plant) and case B (Naphtha-Residual fuel gas mixture GT 2) are taken up as case study. Results show that exergetic sustainability index obtained as for case A is higher as compared to case B.
References
Ahmadi, Gholam Reza, and Davood Toghraie. 2016. “Energy and Exergy Analysis of Montazeri Steam Power Plant in Iran.” Renewable and Sustainable Energy Reviews 56: 454–63. https://doi.org/10.1016/j.rser.2015.11.074
Aljundi, Isam H. 2009. “Energy and Exergy Analysis of a Steam Power Plant in Jordan.” Applied Thermal Engineering 29(2–3): 324–28. https://doi.org/10.1016/j.applthermaleng.2008.02.029
Arpit S., P.K. Das, S.K.dash. 2019. “Thermodynamic Analysis of GT Cycle with Naphtha or Natural Gas as the Fuel: A Thermodynamic Comparison.” International journal of Energy and Environmental Engineering 13(1): 7–10.
Aydin, Hakan. 2013. “Exergetic Sustainability Analysis of LM6000 Gas Turbine Power Plant with Steam Cycle.” Energy 57: 766–74. https://doi.org/10.1016/j.energy.2013.05.018
Aydin, Hakan, Onder Turan, T. Hikmet Karakoc, and Adnan Midilli. 2015. “Exergetic Sustainability Indicators as a Tool in Commercial Aircraft: A Case Study for a Turbofan Engine.” International Journal of Green Energy 12(1): 28–40. https://doi.org/10.1080/15435075.2014.889004
Boles, Cengel. THERMODYNAMICS An Engineering Approach. Fifth.
Butcher, C. J., and B. V. Reddy. 2007. “Second Law Analysis of a Waste Heat Recovery Based Power Generation System.” International Journal of Heat and Mass Transfer 50(11–12): 2355–63. https://doi.org/10.1016/j.ijheatmasstransfer.2006.10.047
Ersayin, Erdem, and Leyla Ozgener. 2015a. “Performance Analysis of Combined Cycle Power Plants: A Case Study.” Renewable and Sustainable Energy Reviews 43: 832–42. https://doi.org/10.1016/j.rser.2014.11.082
Ibrahim, Thamir K. et al. 2017. “Thermal Performance of Gas Turbine Power Plant Based on Exergy Analysis.” Applied Thermal Engineering 115: 977–85. https://doi.org/10.1016/j.applthermaleng.2017.01.032
Kaushik, S. C., V. Siva Reddy, and S. K. Tyagi. 2011. “Energy and Exergy Analyses of Thermal Power Plants: A Review.” Renewable and Sustainable Energy Reviews 15(4): 1857–72. https://doi.org/10.1016/j.rser.2010.12.007
Kaushik, S. C., and Omendra Kumar Singh. 2014. “Estimation of Chemical Exergy of Solid, Liquid and Gaseous Fuels Used in Thermal Power Plants.” Journal of Thermal Analysis and Calorimetry 115(1): 903–8. https://doi.org/10.1007/s10973-013-3323-9
Meeta Sharma, Onkar Singh. 2019. “Exergy Analysis of the Dual Pressure HRSG for Varying Physical Parameters.” Applied Thermal Engineering: 1–9.
Midilli, Adnan, and Ibrahim Dincer. 2009. “Development of Some Exergetic Parameters for PEM Fuel Cells for Measuring Environmental Impact and Sustainability.” International Journal of Hydrogen Energy 34(9): 3858–72. https://doi.org/10.1016/j.ijhydene.2009.02.066
Nag, P K. 2008. Power Plant Engineering. http://science.sciencemag.org/.
Pattanayak, Lalatendu. 2015. “Thermodynamic Modeling and Exergy Analysis of Gas Turbine Cycle for Different Boundary Conditions.” International Journal of Power Electronics and Drive Systems 6(2): 205–15. https://doi.org/10.11591/ijpeds.v6.i2.pp205-215
Rosen, Marc A, and Ibrahim Dincer. 2001. “Exergy as the Confluence of Energy, Environment and Sustainable Development.” Exergy, An International Journal 1(1): 3–13. http://linkinghub.elsevier.com/retrieve/pii/S1164023501000048. https://doi.org/10.1016/S1164-0235(01)00004-8
Szargut, Jan. 2007. “Egzergia. Poradnik Obliczania I Stosowania.” Widawnictwo Politechniki Shlaskej: 1–8.
Turan, Onder, and Hakan Aydin. 2016. “Exergy-Based Sustainability Analysis of a Low-Bypass Turbofan Engine: A Case Study for JT8D.” Energy Procedia 95: 499–506. https://doi.org/10.1016/j.egypro.2016.09.075
Turan, Onder, Hakan Aydın, T. Hikmet Karakoc, and Adnan Midilli. 2014. “Some Exergetic Measures of a JT8D Turbofan Engine.” Journal of Automation and Control Engineering 2(2): 110–14. https://doi.org/10.12720/joace.2.2.110-114
Zhu, Sipeng, Kangyao Deng, and Shuan Qu. 2013. “Energy and Exergy Analyses of a Bottoming Rankine Cycle for Engine Exhaust Heat Recovery.” Energy 58: 448–57. https://doi.org/10.1016/j.energy.2013.06.031
Downloads
Published
How to Cite
Issue
Section
License
Copyright of Published Articles
Author(s) retain the article copyright and publishing rights without any restrictions.
All published work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
